I have seen many others selling the same-ish scale engines as I do.
PLEASE have look at them carefully and compare them to mine or anyone elses.
My 22RE engine is designed to fit on a front mounted motor setup but more importantly I print them at .05mm layers.
The .05 layer thickness allows a much smoother finish but it requires 3 x more time to print(almost 40 hours) yet I sell them for around the same price.
Just look at the details and compare. Then buy mine…. 🙂
I am also working on other scale engines like a Rat Rod inverted 350 and twin turbo supercharged V8
Stay tuned to theLEDwheel.com
I have one 22re Kit version in stock… Get it before someone else does….
Check these out….
BOTH ON SPECIAL
BOTH ONLY 1 IN STOCK
GO GO GO
DONT MISS IT!!!
New EX Real Servo relocation mounts
I made these specifically to get the servo horn out of harms way and this also give the servo arms a better geometry.
I added some chassis sets in different colours for the TA02/FF01 Chassis.
These set will allow you to use LiPo Batteries and are very sturdy.
I setup 3 different colours in the store but Custom colours are available at no extra cost.
However there may be a waiting period as I will have to order the colour and Print the new chassis in said colour.
Waiting period will be determined upon purchase.
The New “theLEDwheel” site is up. Not much here yet but working on it bit by bit.
Lets see if it actually posts to my Facebook Page!!!
Welcome to theLEDwheel’s products site.
The site is currently under construction and should be operational soon.